- 10. What is ESD and does that affect LCDs? Open
ECO sensor detects users' presence in front of the monitor within the set range. If the sensor detects no presence, the monitor is turned off in 40 seconds to save power. If the monitor is turned off by the ECO sensor, the power button flashes in green. If the ECO sensor detect no presence for over 2 hours, the monitor will be powered off. Press the power button to turn on the monitor.
AMA is short for Advanced Motion Accelerator. It' new technology to give greater voltage to liquid crystal, BenQ improve the gray to gray response time and image became clearer and more vivid.
"It might be because the Graphic card (display card) has different setting for digital & Analog input. The user may try to upgrade the latest graphic card driver and adjust the brightness or contrast setting of the Graphic card."
P stands for “preset mode” and is the preferred setting. NP is ""Non Preset"" mode that the monitor supports and image can be displayed. FS: Fail Save Mode. The image can still be displayed but may not be able to displayed correctly because it’s out of range. ""Out of Range"" will be shown. O: Out of Range. The monitor does not support, and no picture would be shown. Therefore, the resolution with P is the preferred setting.
The monitor will only go to standby mode if no signal applied from PC. You can adjust power plan in Control Panel, under Power Options.
For equipment like monitor, it can be used without installing its driver. The drivers that we provide are mainly for 2 functions. 1. To display BenQ Logo on screen for monitors. 2. To improve or upgrade the display quality. Therefore you may choose to ins
A color model is an abstract mathematical model describing colors can be represented as color triangle in attached file, top is Green, left bottom is Blue and right bottom is Red. If color outsides this triangle, it will show gray. The bigger color gamut
Yes, since the LCDs are widely used, some of the applications will be in extreme weather conditions where a wide temperature range is required. Normally the wide temperature range for a TN type LCD is -30 ~ 75C (operation Temp.) and -30 ~ 70C (storage tem
For ITO, the term of resistance is based on ohms per square. Commonly, ITO resistance which we used are 200, 120, 100, 80 and 25 depending on the requirements. The choice could be based on artwork design (such as trace width and area), current requirement
ESD stands for electro-static discharge, it is arc or discharge of electrons between two surface when potential difference is great enough for discharge to take place. Because LCD is made mainly by non-conductive material such as glass and plastic, ESD ca
No, W1300 does not support CEC.
No, QPresenter does not support Windows phones so far.
No, QCast does not support Windows phones so far.
No, receiver is not needed when using PointDraw Pen with MW870UST.
No. MH740 is “PJ Link compatible” and “LAN Control-Crestron eControl / RoomView compatible” (wired). It doesn’t support wireless Lan display.
It is compatibility problem between user's external hard disk and JM-251. Please contact BenQ local service center, we will suggest you proper solution.
It is compatibility problem between user's external hard disk and JM-250. Please contact BenQ local service center, we will suggest you proper solution.
S/PDIF (Sony/Philips Digital Interface Format) is a type of digital audio interconnect cable used in consumer audio equipment to output audio over reasonably short distances. The signal is transmitted over either a coaxial cable with RCA connectors or a fiber optic cable with TOSLINK connectors.
Pulse-code modulation (PCM) is a method used to digitally represent sampled analog signals. It is the standard form of digital audio in computers, Compact Discs, digital telephony and other digital audio applications.
It is the image retention function which can prevent the image persistence on the display when certain color/format had been displayed for a long time. With the image retention function on, the display will switch the pixel to white & black color to prevent the color persist on the display. It can be turn on or off under the advance setting in OSD menu.